HXLIGHTS / SUPPORT

Install guide

HXLIGHTS install guide

A simple bolt-on mount: two pods, two brackets, one harness and the remote. Take your time, and if you are not comfortable with 12V wiring, have a qualified installer do the connection.

What you need

  • The HXLIGHTS kit: 2 pods with brackets, strobe controller harness, 4-button remote
  • Basic hand tools for your bike's fender bolts
  • Zip ties to tidy the cables

1. Pick the spot

Hold each pod beside the licence plate on the rear fender (or another solid spot such as a bag guard or crash bar). Check that it clears the tyre, exhaust, turn signals and the plate itself.

2. Mount the brackets

Bolt one bracket on each side of the plate. Every fender is different, so the brackets may need a little adapting to your bike.

3. Aim the pods

Each pod tilts and swivels on its bracket. Point both pods straight back and level with each other, then tighten the side bolts.

4. Connect to 12V

Plug the pods into the strobe controller harness. Connect the harness to a fused, switched 12V supply and ground, following the wiring instructions in the box. Route the cables away from hot or moving parts and secure them with zip ties.

5. Pair and test

Test the four buttons on the remote: on, off, slow flash and fast flash. Keep the remote on your keys.

Need help?

Send us your make, model and year through the contact page and we will help you plan the install.

Rules for strobe lights depend on your country.

Your bag

Opening your bag…